Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 7-7 (First Silicon Vacuumbag)



FACEBOOK: http://www.facebook.com/MAT2COMPOSITES
TWITTER: @matthieutje65
INSTAGRAM: MatthieuLibeert
WEBSITE: http://www.matthieulibeert.webs.com

Watch introduction video of this project here!

https://www.youtube.com/watch?v=Ef2nE…

Links:

VOSSCHEMIE: (vg alu epoxy) http://www.vosschemie-benelux.com
—————————————-­—————————————-­——————-

EASYCOMPOSITES: (Chemical release agent)

http://www.easycomposites.co.uk/products/release-agents/easylease-chemical-release-agent.aspx

EASYCOMPOSITES: (Prepreg)

http://www.easycomposites.co.uk/Category/Fabric-and-Reinforcement/Pre-Preg-Carbon-Fibre.aspx

EASYCOMPOSITES: (Vacuumpump) http://www.easycomposites.co.uk/products/vacuum-bagging/composites-vacuum-pump.aspx

New video online every Wednesday at 18:00 Belgian time!
Schedule:

1 January 2014
Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 1-7 (Introduction)

https://www.youtube.com/watch?v=Ef2nE…

8 January 2014
Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 2-7 (CNC+2K Paint)

https://www.youtube.com/watch?v=fWiPl…

15 January 2014
Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 3-7 (Casting ALU VG)

https://www.youtube.com/watch?v=WzvLM…

22 January 2014
Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 4-7 (Prepreg mould)

29 January 2014
Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 5-7 (Complex moulds)

5 February 2014
Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 6-7 (First Parts and Clear)

12 February 2014
Tutorial: Out Of Autoclave PREPREG Carbon Fiber/Fibre Part 7-7 (Silicone bag and parts)

In this video I show you how I made my first prototype of a silicone vacuumbag. By using a silicone vacuumbag you reduce waste and costs of making parts with a vacuumbag. The silicone vacuumbag can be re-used as many times as you want. the bag is selfreleasing as well saving you some costs on release agent and so on as well.
There is ofcours a lot of room of improvement after this first vacuumbag but all of this was a first test of making such a bag!

After the succes of a previous 6-part tutorial from mouldmaking till prepreg parts, here are some new ones! you can see the introduction of the previous tutorials by clicking on following link: https://www.youtube.com/watch?v=1PpKM…

In the videos coming online you will get some information on 2K spraypaint, How the first moulds were CNC-Milled, The use of Vosschemie VG ALU EPOXY, using Prepreg Carbonfiber to make moulds, how an other mould was made to enable silicone vacuumbags, how parts are clearcoated and many more. So if all of this sounds interesting, don’t forget to subscribe ;)

Track ID on background: Blackmill – Spirit Of Live


Post time: 03-31-2017