Lifecasting Tutorial: How to Make a Mold of Your Hand with Alginate



In this lifecasting tutorial video clip, we display how to use alginate to make a mold of a hand.

Step 1: Evaluate and Mix
Mix Ratio: one section Alja-Safe to one section water by volume. Increase to start with cup of Alja-Safe and start off mixing. Increase 2nd and third cups of Alja-Safe. Mix to a creamy regularity, no lumps.

Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Damp the model’s hand in advance of positioning it into the Alja-Safe. Keep hand one/2 inch (one.27 cm) higher than the bottom of the container. Allow Alja-Safe set for 8-ten minutes, until eventually good.

Step A few: Demold
Bit by bit and meticulously get rid of hand. Eliminating the product far too rapid may possibly end result in a tear in the mold. Prepared to cast.

Step Four: Casting into the Alja-Safe Mold with Easy-Forged 300Q Ultra-Rapidly Urethane Resin
Implement Universal Launch Agent. Dispense Section A. Dispense Section B. Combine equally components in mixing container. Mix thoroughly. Rotate mold to limit air entrapment. Plastic will heal in considerably less than a single moment.

Step Five: Demold the Resin Casting
Perfectly in-depth copy. Implement primer. Implement paint.

How very long did it choose to make the mold?
Get started to Finish: twenty five Minutes

How very long did it choose to make the casting?
Get started to Finish: fifteen Minutes

How significantly Alja-Safe was applied?
Fewer than one lb (.forty five kg)

Use Your Imagination:
* Chilly Forged Metallic Effects
* Build Various Colour Effects
* Very clear Resin Effects (further mold generating & casting needed)

Starter Package Readily available at: http://www.smooth-on.com/Getting-Commenced-Li/c4_1219/index.html

Make It Now! with Easy-On

http://www.smooth-on.com/

http://www.facebook.com/SmoothOn

http://twitter.com/SmoothOn

http://www.google.com/+smoothon


Post time: 06-28-2016