Extrusion Blow Molding – Lesson 1 – The Procedure and the Devices



This is an excerpt from Lesson #1 in Paulson’s Extrusion Blow Molding Technologies schooling progam. This lesson is titled “The Procedure and the Devices”.

You can look at more Paulson schooling movies at our Plastics Coaching Center. Signal up below: http://plasticstrainingcenter.com/injection-molding-schooling-yt

Facts on the finish Extrusion Blow Molding Technologies schooling plan can be uncovered at:
http://www.paulsontraining.com/products and solutions/extrusion-blow-molding-technological know-how/

By employing a comprehensive schooling resolution for your company, you will be equipped to have a continual pool of extremely skilled candidates to boost from in or to fill in on the produciton ground as desired.

Coach manufacturing staff, supervisors and professionals to recognize the basics of extrusion blow molding technological know-how, plastic actions all through the blow molding course of action, device established-up for ideal manufacturing operates and frequent difficulty resolving predicaments. The training course will prepare your blow molding staff to:

1. Develop a operating know-how of blow molding equipment
2. Assess and increase functioning methods
three. Figure out processing problems that impact quality
4. Analyze and address simple blow molding challenges

Lesson 1 – The Procedure and the Devices
Lesson 2 – Plastic Actions
Lesson three – Extrusion Blow Molding Working Controls
Lesson 4 – Working Processes – Start out-up, Procedure, and Shutdown
Lesson five – Part Top quality and Difficulty Solving – Part 1
Lesson 6 – Part Top quality and Difficulty Solving – Part 2
Lesson seven – Parison Programming


Post time: 09-08-2016