Casting Smaller Plastic Parts #2



Continuation from 1st vid. Right here I am earning the small exhaust manifolds for the Deltic product. These very little sections use 1cc of plastic, even though my big Deltic engine block uses 550cc! I measure the plastic with syringes for the small to medium sized sections, and use disposable measuring cups for much larger volumes. The types I use have been acquired at a farm source retail store, I consider they have been employed for measuring small animal feed, and maintain 150cc.

#1 rule, constantly dress in safety eyeglasses, you never ever know when a splash or spill can transpire, going blind would just is not worthy of the possibility!
Also, any imperfection in your mold will demonstrate up in your solid sections, so getting added time up front will help save you sections clean up time Each and every time you make a new copy!


Post time: 10-25-2016