An introduction and overview for a sequence of films showing how I’m working with 3D printing for mould generating. The sequence will cover inspecting, restoring, signing up for, plastic welding and finishing FFF printed Ab muscles components for mould generating.
The sequence would also be of desire for anybody intrigued in submit print finishing.
A 2nd sequence will comply with showing some of my procedures for casting mild body weight components, suitable for radio controlled aircraft in urethane foam.
You can comply with the 30mm EDF Hawker Hunter RC challenge on the RC Groups Micro EDF discussion board – http://www.rcgroups.com/community forums/showthread.php?t=2085592
Many thanks for viewing!
Post time: 02-13-2016